Printer Cabinet iPhone 5s Mount

I designed this phone mount so I could slide my iPhone 5s into the right hand side and back out for easy removal. There’s a small hole at the bottom middle for the charger to go through. The top and bottom pieces are simply double sided taped (the good stuff :P) to my printer cabinet, with the top piece having it only on the left side so you can push down on it a bit and actually trigger the power button while it’s in place.

I’ve designed it to fit my fairly slim case, so it should work with at least some cases, but definitely not thicker ones unless you scale it a bit.

Monitoring app used is OctoClient for OctoPrint

 

 

Printer: Monoprice Maker Select V2

Rafts: Doesn’t Matter

Supports: No

Resolution: .2mm for speed

Infill: 20%

Note: Print both so the open side faces up for best results

How I Designed This

Designed in Rhinoceros 3D 5

 

Download/Thingiverse Page Here!

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

%d bloggers like this: